WIRECRIMPING PLIER & 10' NWFW
110 TO 220-VOLT POWER CONVERTER
Step-Up or Step-Down Transformer
Converts 110/120 Volts to 220 /240Volts and 220/240 Volts to 110/120 Volts
300 Watt Capacity
Allows you to use electric tools in other countries.
Power Controller – Use nothing longer than a 50 foot 12/3 grounded extension cord. Set the temperature dial on the controller to zero (0). Turn on the hot wire power controller and adjust the dial until the wire glows orange. Immediately back off the controller until the heated wire just begins to turn from orange to gray. This is the optimum foam cutting temperature of the wire. Anything hotter will cause premature wire failure or anything cooler will require too much feed pressure on the wire causing premature failure. If the wire is too hot, the cut may not be as accurate as you would like. A wire that is too hot will melt the foam too quickly at the beginning of the cut and less quickly as the wire cools off resulting in an inaccurate cut.