FOAM-LOK ADHESIVE - 5 GAL (WATER BASED POLYURETHANE) * BLUE TINTED
FOAM-LOK™ FOAM ADHESIVE — WATER BASED
Foam Lok FLA6B is a non-flammable, non-toxic, aqueous emulsion adhesive for general purpose bonding of foam, fiberglass, plywood, fabrics, carpets, rubber, certain plastics, and leather.
- Approx 420 sq. foot coverage
- High Solids
- Superior Coverage
- Excellent Water Resistance
- Low VOC
- Easy Clean Up
- Fast One Part Adhesive System
- Dyed Blue for Enhanced Visibility
Surfaces must be clean and dry. Spray an even coat of adhesive to both surfaces to be bonded. Allow both surfaces to become tacky before bonding, usually 2 to 7 minutes. Tack time varies depending on atmospheric conditions such as temperature and humidity, as well as the amount of adhesive applied. Place both surfaces to be bonded in the exact position desired within 20 minutes of adhesive application. If the two surfaces do not grab immediately when brought into contact they have dried too long. The adhesive may be reactivated by applying another thin coat over each surface. Press from center outward in all directions.
FOAM-LOK™ will perform as intended - your results could differ if you do not follow the directions. Also, atmospheric conditions, temperature and thickness of application may vary the results. We suggest a trial test with each application to determine acceptable results.
Chemicals are Prohibited on all International and Domestic Air Shipments.