Details

HOBBY HOT WIRE EPS FOAM CUTTER TABLE

The Hot Wire Foam Cutter HCM2S is designed for cutting EPS foam (Styrofoam) by using a Hotwire.  Cutting by wire doesn't produce dust or chips ensuring a clean surface.

• Built-In Variable Power Supply with 3 Heat Settings

• 8-Inch Hot Wire Cutting Height

• 12" x 22" Foam Cutting Table

• Good for Holiday decorations, model builders, architects, interior designers, school arts, sign designers and prototype makers.

• Fold angle setting stop to set & consistently repeat and bend

Tech Specs

Note: Heated Wire expands when hot. If the spring is too tight the wire may break restricting operation of mechanism. If too loose, the
cut will be sloppy. Readjustment of tension may be necessary from time to time.

Safety Tips

Power Controller – Use nothing longer than a 50 foot 12/3 grounded extension cord. Set the temperature dial on the controller to zero (0). Turn on the hot wire power controller and adjust the dial until the wire glows orange. Immediately back off the controller until the heated wire just begins to turn from orange to gray. This is the optimum foam cutting temperature of the wire.  Anything hotter will cause premature wire failure or anything cooler will require too much feed pressure on the wire causing premature failure. If the wire is too hot, the cut may not be as accurate as you would like. A wire that is too hot will melt the foam too quickly at the beginning of the cut and less quickly as the wire cools off resulting in an inaccurate cut.

• Use only the recommended wire. NWMANIX

• Do not use this equipment in wet or damp conditions.
• Use only grounded receptacles.

Warranty Info

Return Policy
No merchandise can be returned without an authorization number. We do not accept returns on chemicals or coatings. Returns must be made within 15 days of invoice and must be in new condition. Materials returned must be shipped prepaid. Discontinued items, custom orders or items that have been out of our factory for 3 months or longer cannot be returned. Returns subject to minimum 15% restocking fee.

Warranty
All of our products carry an unconditional 6-month guarantee, but Demand must be notified within 48 hours of receipt of defective or damaged merchandise or shortages. Defective products will either be replaced or repaired at no charge. Abused tools will be repaired and returned only if the customer consents to charges in writing.

Please Note - Disclaimer
The products in this catalog are offered as options for the purchaser. Having no control over the use of the products in this catalog, we assume no liabilities connected with their use. Under no circumstances are we or the seller liable for any loss, damage or expense of any kind arising out of the use or inability to use our products.